Advertisement
●
Choose the location to ensure largely interference-free reception. When mounting the
receiver, observe the following:
–
–
–
–
Wiring
●
The AC 230 V mains supply line must have an external circuit breaker with a rated
current of no more than 10 A.
●
Ensure that wiring, protection and earthing comply with local regulations.
●
Adapt the line diameters as per local regulations to the rated value of the installed
overcurrent protection device.
●
Disconnect from power supply before removing the unit from its mounting plate.
●
Make sure the receiver is not connected to power during wiring.
Commissioning
LED indication on RCR114.1
RCR114.1 has one LED to indicate its status.
Device status
Idle
Connecting to RDS110.R
Successful connection
Thread network works, but communication with RDS110.R
failed
Thread network failure
Factory reset
1. Reconnection is performed automatically or manually.
2. Reconnection can only be performed manually.
Manual network reconnection
1. Check whether RDS110.R is powered on and in normal operation.
2. If the reconnection still fails, delete RCR114.1 in the device list of RDS110.R, then long
press button
Smart Infrastructure
Do not mount in a control panel
Do not mount on metallic surfaces
Do not mount near 2.4 GHz wireless electronic devices such as PCs, WiFi routers,
microwaves, etc.
Do not mount near constructional elements with fine metal or large metallic
structures such as a distribution box
1)
2)
on RCR114.1 for 8 seconds and re-add RCR114.1 to the device list.
LED status
Solid yellow
Flashing green
Solid green
Flashing red
Solid red
Alternating red and green
5
A6V11562464_en--_a
2019-09-19
Advertisement
