Table of Contents
Advertisement
40 Installation checklist
Check that ...
The setting of the voltage selection jumper is correct. See section
Selecting the voltage
on page 34.
The DC cable has been connected to the appropriate terminals, and the terminals have been
tightened. (Pull the conductors to check.)
Appropriate DC fuses have been installed.
The resistor cable has been connected to the appropriate terminals, and the terminals have been
tightened. (Pull the conductors to check.)
The brake resistor cable has been routed away from other cables.
The control cables have been connected to the appropriate terminals, and the terminals have been
tightened. (Pull the conductors to check.)
There are no tools, foreign objects or dust from drilling inside the brake unit cabinet.
All shrouds and the front panel of the brake chopper module are in place. Cabinet doors have been
closed.
Advertisement
Table of Contents
