AEG BSK892330M User Manual page 53

12.1 What to do if...
Problem
You cannot activate or oper‐
ate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display prompts to set
the Language.
The display prompts to set
the Language.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance does not re‐
tain the water drawer after
you insert it.
Possible cause
The oven is not connected to
an electrical supply or it is
connected incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
The fuse is blown.
The lamp is defective.
There was a power cut lon‐
ger than 3 days.
The demo mode is activated. Turn off demo mode in:
The plug of the food sensor
is not correctly installed into
the socket.
There is an electrical fault.
You left the dish in the oven
for too long.
You did not assemble the lid
of the water drawer correct‐
ly.
ENGLISH
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec‐
tion diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Replace the lamp.
Refer to "Before first use"
chapter.
Menu / Basic Settings /
DEMO. Activation / deactiva‐
tion code: 2468.
Put the plug of the food sen‐
sor as far as possible into
the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De‐
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Assemble the lid of the water
drawer correctly.
53