System 800Xa Control 6.0 Ac 800M Planning, 3Bse043732; System 800Xa Control 6.0 Ac 800M Binary And Analog Handling, 3Bse035981; Ac 800M 6.0 Communication Protocols, 3Bse035982 - ABB System 800xA Operations

System 800xA Control 6.0 AC 800M Planning, 3BSE043732* Section 1 Safety Operator Warnings
Non-Cyclic Execution in Debug Mode
Functions based on the real-time clock (PID controllers, timers, etc.) cannot be
properly debugged in Debug mode. Timer functions will take into account the actual
time elapsed since started, regardless if, for example, the task is halted in Debug
mode.
Tasks
If debug mode is used in a running plant, task execution will be stopped.
Upgrading Controller Firmware using Backup Media
The firmware upgrade function in PM85x-PM86x controllers uses a low level
function to locate a special "boot" file on the CompactFlash card which does not
depend on the normal file system. Hence it may find this file even if it has been
deleted unless a thorough reformatting has been done. See chapter Remove Files
Completely from a CompactFlash Card.
System 800xA Control 6.0 AC 800M Planning,
3BSE043732*
There are no safety warnings in this manual.
System 800xA Control 6.0 AC 800M Binary and Analog
Handling, 3BSE035981*
There are no safety warnings in this manual.

AC 800M 6.0 Communication Protocols, 3BSE035982*

This section lists the warnings mentioned in the AC 800M 6.0 Communication
Protocols manual.
Warnings
28 2PAA110888-600 - Warnings based on 3BNP004865-600 RevA