Table of Contents
Advertisement
1.
Set system wide DNS server addresses.
2.
Configure network settings for available network adapters.
3.
Save and apply all network settings.
You can select Quit+ENTER at any time to exit the wizard.
When assigning static IP settings, the required information is:
An IP Address for the device e.g. 192.168.1.50
Subnet Mask e.g. 255.255.255.0
Default Gateway (address of the server or router which provides external network connection)
e.g. 192.168.1.1
Optional information is:
Domain Name (domain extension for the device) e.g. hp.com
DNS server addresses (address of the server which translates hostnames to IP addresses) e.g
192.168.1.1
Before running the wizard
Before running the wizard you must make a number of decisions about your network configuration.
1.
Do you wish to configure DNS servers? Up to 3 may be configured. Make sure you have the
address details before you start.
2.
Are you connecting a single port or are you connecting two ports to your network?
3.
Which Ethernet port(s) are you connecting? Bonded pairs will be eth0 and eth1 for HP
StoreOnce 2620/4210/4220 Backup systems. For the other HP StoreOnce Backup systems,
eth0/eth1 are the 1GbE ports; eth4/eth5 are the 10GbE ports. You cannot bond a 1GbE
with a 10GbE port.
4.
Which network bonding mode is required, the default is Active/Passive bonding?
5.
Does your network use DHCP or static IP addresses? If you select static IP addressing, make
sure you know:
IP address of the HP StoreOnce Backup system
Subnet mask
Gateway IP address (optional, the gateway can also be obtained from DHCP)
Domain name, such as mycompany.com (optional, the domain name can also be obtained
from DHCP)
6.
The above information is sufficient to configure the network and once entered, the wizard will
display and ask you to confirm the settings you have specified. At this point, do you wish to
configure a second subnet? For example, you may wish to dedicate one network to replication.
Or, with HP StoreOnce 4430/4420 Backup systems, you may wish to use the 10GbE network
for data and the 1GbE network for StoreOnce management.
You will be prompted to provide details of the second subnet, as above. You are also asked
to select which subnet will provide the default gateway.
To run the wizard
1.
To run the wizard, connect a console directly to the appliance and, using puTTY (or other
ssh application, log into the StoreOnce CLI.
2.
Enter the command:
net set wizard
The network configuration wizard
19
Hide quick links:
Advertisement
Table of Contents
