Amibios Power-On Self Test; Inside Interrupts; Fig. 9-16:Beep Codes - Bosch Rexroth Indramat BTV30.2 Project Planning Manual

BTV30.2

AMIBIOS Power-On Self Test

If it beeps...
1, 2, or 3 times
6 times
8 times
9 times
11 times
4, 5, 7, or 10 times

INSIDE Interrupts

DOK-MTC200-BTV30.2****-PR02-EN-P
Every time the system is powered on, AMIBIOS executes a power-on self
test. In case of errors they are reported in one of two ways. If the error
occurs before the display device is initialised, a series of beeps sound.
Beep codes indicate that a fatal error has occurred. AMIBIOS Beep
Codes are described in the table below.
Then...
Re-insert the memory SIMMs. If the system still beeps replace the
memory.
Try a different keyboard or replace the keyboard fuse if the keyboard
has one.
There is an error on the Video adapter or the Video RAM
The BIOS ROM chip is bad. The system probably needs a new BIOS
ROM chip.
Re-insert the cache memory on the board. If it still beeps, replace the
cache memory.
Fatal error.
Fig. 9-16: Beep Codes
If the error occurs after the display device is initialised, an error message
is displayed.
The interrupt number is selected in the INSIDE Utilities setup menu.
By loading the desired function number in the AL CPU register and
generating a software interrupt with the INT X instruction the function is
called. X is the interrupt number specified in the Inside utility setup. Some of
the functions will require an additional value loaded in the AH register.
9-13
SLOT-CPU Card