Dryer Rack; Changing Modifiers And Options After Pressing Start; Changing The Preset Dryness Level Settings - Kenmore Oasis 110.67032600 Manual

CHANGING MODIFIERS AND
OPTIONS AFTER PRESSING START
You can change a Modifier or Option anytime be-
fore the selected Modifier or Option begins.
1. Press STOP once.
2. Select the new Modifier and/or Options.
3. Press START to continue the cycle.
NOTE: If you happen to press STOP twice,
the program clears and your dryer shuts down.
Restart the selection process.
CHANGING THE PRESET
DRYNESS LEVEL SETTINGS
If all your loads on all Auto Dry cycles are con-
sistently not as dry as you would like, you may
change the preset Dryness Level settings to
increase the dryness. This change will affect
all of the Auto Dry cycles.
The Dryness Level settings can be adjusted to
adapt to different installations, environmental
conditions or personal preference. There are 3
drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately 15%
more drying time) and 3 (much dryer clothes,
approximately 30% more drying time).
1. The Dryness Level settings cannot be
changed while the dryer is running.
2. Press and hold the Dryness Level button for
5 seconds. The dryer will beep, and "CF"
will be displayed for 1 second followed by
the current drying setting.
3. To select a new drying setting, press the
Dryness Level key again until the desired
drying setting is shown.
NOTE: While cycling through the settings,
the current setting will not flash, but the
other settings will flash.
4. Press START to save the drying setting.
5. The drying setting you selected will become
your new preset drying setting for all Auto
Dry cycles.

DRYER RACK

The dryer rack was shipped inside of the drum.
Remove and discard shipping blocks before
use.
Use the dryer rack for items that you do not
want to tumble dry, such as sweaters.
Use Timed Dry to select the desired time.
NOTE: Do not use Auto Dry Cycles with the
dryer rack.
To use the dryer rack:
Do not remove the lint screen.
1. Open dryer door.
2. Slide dryer rack over the bottom of the dryer
door opening, rest the back wire on the dryer
back ledge. Push down on the frame front
to secure over lint screen.
3. Place wet items on top of the rack. Allow
space around items for air to circulate.
The rack does not move, but the drum will
rotate. Make sure items do not hang over
the edges or between rack grille.
3-8