Sony BKM-FW50 Service Manual page 11

2-3. Preparation
2-3-1. Required Equipment
. Monitor (FWD-32LX1R/40LX1/40LX2/40PX2/50PX2 etc.)
. This unit (BKM-FW50)
. Personal computer (hereafter referred to as PC)
. BKM-FW50 version update firmware
In the case of Network Management
bootloader.rom: boot file (usually not used)
image debug.rom: Network Management application file
updater.rom: Updater file
In the case of Streaming Controller
vxWorks.rom: Streaming Controller application file
. BKM-FW50 firmware writing software:
Firmware Update.exe
n
The file name may be changed depending on the
firmware version.
Use the latest version of Firmware Updater.
. Router
. Ethernet cable (2 pcs)
2-3-2. Connection
BKM-FW50
OPTION1 slot
(Install in VIDEO/COM)
Ethernet
cable
Router
n
Connect the Ethernet cable to the LAN side of the router.
Never connect it to the WAN side.
BKM-FW50
Monitor
(FWD-40LX1/42PV1/50PX2 etc.)
Ethernet
cable
PC
2-4. Version Update
m
Observe the following items in the version update.
. Do not turn off the power of the monitor and router
during the version update.
. Do not use bootloader.rom unless it is required.
. In the mode of Network Management, do not use the file
other than "Network Management".
. In the mode of Streaming Controller, do not use the file
other than "Streaming Controller".
2-4-1. IP Address Acquisition
In order to access via the Web browser, acquire the IP
address of this unit in the following procedure.
1. Turn on the power of the monitor.
2. Press the [Menu] button of the monitor or remote
controller.
3. Select "Initial setting/Information" using the [(] and
[)] buttons and push the [Enter] button.
4. Select "Information" using the [(] and [)] buttons and
push the [Enter] button.
The IP address is displayed on OSD.
2-5