Connect S2 | Solar Frame | User Guide
Mounting with Solar Frame, glued on backside
INFO
The mounting material supplied is suitable for a carrier plate with a material thickness of 1 mm to
13 mm.
•
•
Follow the instructions for using the AT-8040 adhesive in this chapter!
Mounting parameters:
Thickness of the mounting surface
Tightening torque of the flange nuts M5
Mounting steps:
1. Mark holes using the Solar Frame
2. Drill holes
3. Fix the gluing studs according to the gluing instructions
4. Wait for the adhesive to harden
5. Activate gateway
6. Connect Solar Frame connector to gateway
7. Insert the gateway into the Solar Frame from below
8. Mount the supplied washers
9. Mounting according to exploded view
10. Check that all four mounting points hold the Solar Frame
11. Close the screw holes with the supplied plugs
Exploded view
© Robert Bosch Manufacturing Solutions GmbH
The mounting holes are sealed with the supplied adhesive.
This type of installation can be carried out by one person.
1 mm to 3 mm
4 mm to 13 mm
hand-tight
Rear view
Mounting set 0 mm – 3 mm
Mounting set 4 mm – 13 mm
Side view
Bosch Connected Industry
22 | 39