Sealey ES500.V2 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instructions gloves
1. safEty
ensure that the engine support is in good working order. Take action for immediate repair or replacement of damaged parts. Use
9
genuine parts only. The use of unauthorised parts may be dangerous and will invalidate the warranty.
locate the vehicle in a suitable, well lit work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
ensure the vehicle handbrake is engaged and the engine/motor is switched off.
9
ensure all non-essential persons keep a safe distance whilst the engine support is in use.
9
Do not use the engine support if damaged.
8
Do not allow untrained persons to operate the engine support.
8
Do not use the engine support for purposes other than that for which it is designed.
8
Do not exceed the rated capacity of the engine support.
8
When not in use, store engine support in a safe, dry, childproof area.
9
2. introDuction
designed to support and accurately position engines during maintenance operations such as replacing anti-vibration mountings and
certain body panels. Also used as an aid for the removal of gearboxes and transmissions. Beams supported on rubber feet and
fine adjustment control is obtained by using screw/hook mechanism. Supplied with a short length of chain.
3. spEcification
Maximum Capacity ..........................................................500kg
Minimum Width ............................................................1120mm
Maximum Width ...........................................................1910mm
Screw Travel ..................................................................230mm
Weight ..........................................................................14.02kg
4. contEnts
item Description
1 Grip (handle bar)
2 operating clamp assy.
3 Washer 22mm internal Ø
4 Grip
5 Washer 11mm internal Ø
6 Telescopic beam
7 Standing block
8 Washer 21mm internal Ø
9 Bolt & locknut 16mm
10 Grip (small)
11 Foot
12 Rubber block
13 Adjustable screw
14 Chain
15 Beam
© Jack Sealey limited
EnginE support bEam 500kg
Model no:
Wear safety Wear protective
footwear clothing
fig.1
Original Language Version
Es500.V2
eS500.V2 Issue 4 (HF) 22/08/18