Sealey TDMCRW Instructions

Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. SAfETy
When selecting web lashings (tie downs) consideration must be
9
given to the required lashing capacity, taking into account the
mode of use and the nature of the load to be secured.
tie downs must be strong enough and of the correct length for
9
the mode of use.
take care that the load is stable when the tie down is released.
9
Avoid exposure of the tie down to chemicals.
9
do noT use if tie down is damaged. A visual inspection before
8
use is recommended.
Avoid sharp edges. Protect tie downs by using sleeves or
9
corner protectors.
do noT overload.
8
do noT use if knotted.
8
2. InTroducTIon
manufactured from polyester webbing. Stitched reinforcement at joins and loops. Suitable for workshop use or for securing motorcycle to flat-
bed or trailer. secures rear wheel to anchor point without compressing the suspension units, thus reducing the risk of seal damage. ratchet
mechanically tensions the webbing using a simple drum and ratchet mechanism for superior load restraint.
3. SpEcIfIcATIon
model no ................................................................ tdmcrW
maximum tension ........................................................500Kg
load test ...................................................................1000Kg
Webbing Width ............................................................. 35mm
4. opErATIon
4.1. Position straps around rear wheel as shown in fig 2.
4.2. Attach hook fig 3. to anchor point so as to pull the bike forward.
4.3. using ratchet tighten strap until wheel is clamped into position.
© Jack sealey limited
instructions for
TIE down - moTorcyclE rEAr whEEl
Tdmcrw
model no:
Original Language Version
fig.1
fig.2
fig.3
tDMCRW | Issue 1 02/01/18