Sealey TDMCHB Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
When selecting web lashings (tie downs) consideration must be
9
given to the required lashing capacity, taking into account the
mode of use and the nature of the load to be secured.
Tie downs must be strong enough and of the correct length for
9
the mode of use.
Take care that the load is stable when the tie down is released.
9
Avoid exposure of the tie down to chemicals.
9
DO NOT use if tie down is damaged. A visual inspection before
8
use is recommended.
Avoid sharp edges. Protect tie downs by using sleeves or
9
corner protectors.
DO NOT overload.
8
DO NOT use if knotted.
8
2. INTRODUCTION
Manufactured from polyester webbing with stitched reinforcement around loops. To be used in conjunction with suitable ratchet tie downs.
Suitable for workshop use, to provide safe restraining points for securing motorcycles to a work bench, flat-bed or trailer. Simple cam buckle
fastener tensions the webbing to provide superior load restraint.
3. SPECIFICATION
Model No .................................................................TDMCHB
Maximum Tension ........................................................350Kg
Load Test .....................................................................700Kg
Webbing Width ............................................................. 35mm
Max. Handlebar Restraint Width ................................ 750mm
4. OPERATION
4.1. Place strap centrally across handle bars.
4.2. Position red section of strap over handle bar grip fig.2.
4.3. Place through loop fig.3. Pull strap tight.
4.4. Pass end of strap through second loop fig.4.
4.5. Let end of strap hang, ready for attaching to fixing point. fig.5.
4.6. Repeat for second handle bar grip.
4.7. Tighten strap between handle grips fig.6.
fig.4
© Jack Sealey Limited
TDMCHB.indd 1
INSTRUCTIONS FOR
TIE DOWN - MOTORCYCLE HANDLEBAR
TDMCHB
MODEL NO:
fig.5
Original Language Version
fig.1
fig.2
fig.6
TDMCHB | Issue 1 02/01/18
fig.3
24/01/2018 08:52:58