Removal Of The Puncture Guide Tube - Hitachi C41RP Instruction Manual

4-5. Removal of the puncture guide tube

(1) When grips on the top of the puncture guide tube holding clip are squeezed from both sides, the holding clip opens.
(2) Open holding clip and pull up the puncture guide tube as shown in figure below.
(3) Immediately wash and sterilize the puncture guide tube after it is removed from the probe.
Note
After use of the probe and puncture guide tube, immediately care of them.
If the probe and puncture guide tube are left uncleaned for a long period of time after use, the adhered muci-
lage and blood coagulate make difficult to care for them.
Figure 12 Removal of the puncture guide tube 1
Figure 13 Removal of the puncture guide tube 2
Squeeze grips
from both sides.
Holding clip
opens.
-15-
MN1-5827 Rev. 6