Name Of Each Parts - Hitachi C41RP Instruction Manual

2-2. Name of each parts

The name of each part is shown in Figure 3 and the explanation for each part is listed in Table 4.
Name
Ultrasonic radiation part
Front mark
Probe tip
Handle
Insertion portion
Grip cover
Cable
Connector
Puncture guide tube
Rubber boot
Front guide
Rubber boot
Insertion portion
Ultrasonic radiation part
Front mark
Connector
Figure 3 Name of each parts
Table 4 Name of each part and its explanation
Ultrasound is radiated from this part. The electronic convex transducer is
integrated underneath this part.
The dimple corresponds to the side of the orientation mark on the image.
The probe tip is the part includes both the insertion portion and the handle.
This part is held during operation.
This part is inserted into the patient.
Please do slide on the cable side and detach it when you do puncturing.
Cable transfers electric input/output signals.
The connector is the part which is connected to the ultrasound diagnostic
instrument.
This tube is attached to the probe to help insert the probe needle. Attach ir
as per the instructions in section 4-4.
Cover the insertion portion with this rubber boot to prevent infection.
Follow the instructions in section 4-2.
Rear guide
Guide tube
Holding clip
Probe tip
Handle
Explanation
-5-
Puncture guide tube
Grip cover
Cable
MN1-5827 Rev. 6