Page 1
How to connect an Epson wireless POS printer Home Sale Specials Printers Accessories Service Support About Us Contact Catalog How to connect an Epson TM Series Printer with a Wireless Adapter Printers Overview U220 Installing Adapter Network Setup U200 Checking Adapter Settings Configuring Router Configuring Computer...
Epson PS-180). If changing a printer to wireless you must change the specific dip switch on the Epson printer to allow for the wireless card. (Key: DIP SW2-8 On: refers to the switch number 8, on switch bank 2, is turned On) Network Setup The wireless adapter can be "connected"...
Page 3
How to connect an Epson wireless POS printer Getting Initial Printer and Wireless Adapter Settings Get the initial settings of the wireless adapter. Run the printer self test (hold down the feed button while turning on the printer). The printer will print a list of initial settings including SSID (network ID), Mode (Ad-Hoc or Infrastructure), current IP address (default: 192.168.192.168)
Page 4
How to connect an Epson wireless POS printer A sheet will print showing the MAC address, SSID, mode, wireless channel number, authorization method (None, WEP), Gateway (GW), IP address and IP assignment method. The network specific settings have been highlighted above.
Page 5
How to connect an Epson wireless POS printer Manual setting IP addresses are assigned on your network. Use WEP None None / 64-bit / 128-bit WEP Key None set this if key is used Channels 1-11. When using Ad-Hoc mode, Channel the channel directly.
Page 6
How to connect an Epson wireless POS printer your IP Address are not 192.168.192, (Ex. 192.168.1), then you need to change your computer's IP address to an address in the same subnet. Change the IP address to a static IP address. Then make the IP address of the adapter different than the wireless adapter (like 192.168.192.2).
Page 7
How to connect an Epson wireless POS printer If you are using a wireless router then you should verify that the printer is connected to the router. Turn the printer on Log onto the router administration from a computer on the network.
How to connect an Epson wireless POS printer less than 10 minutes). This is a process controlled by Epson not Beagle Hardware. TECHNICAL RESOURCES 5. Click on WIRELESS INTERFACES CONNECT-IT INTERFACES 6. Select under the download icon for the TMNetWinConfig 7.
Page 9
How to connect an Epson wireless POS printer Configuring the Printer in Windows You need to make a few changes in the printer settings to get it to work with the wireless adapter. Specifically you need to configure the port you are using. Open the printer in the Windows Printer Folder. Select the Ports Tab. Turn off bidirectional support, if enabled.
IP address. The Epson printer driver has not been installed for the wireless adapter and printer in use. The network mode is not correct. If the computer is in the AdHoc mode, the wireless adapter must be in the AdHoc mode.
How to connect an Epson wireless POS printer WEP key setting is not correct. If setting is not possible, initialize the wireless adapter. Install the wireless adapter in the TM printer, turn the power on, and press the Mode button of the wireless adapter for more than three seconds to re-initialize the wireless adapter.