Sealey WB65 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
Always distribute the load evenly over the surface of the wheelbarrow.
9
DO NOT overload the wheelbarrow.
8
DO NOT use wheelbarrow on uneven ground and DO NOT run over curbs or steps - use a ramp.
8
DO NOT allow others to ride in the wheelbarrow.
8
DO NOT use the wheelbarrow if any part is damaged, paying particular attention to the wheel.
8
DO NOT inflate the tyre to more than 25psi.
8
2. INTRODUCTION
Lightweight galvanized steel wheelbarrow ideal for a wide range of gardening and light construction applications,
as well as general domestic use. Constructed with strong tubular steel frame and rubber gripped handles. Fitted
with 340mm pneumatic tyre.
3. CONTENTS
• Pan
• Frame x 2
• Frame spacer x 2
• Pan support
• Bolt x 6
• Nut x 6
• Washer x 6
4. SPECIFICATION
Model No:.................................................................... WB65
Capacity: .......................................................................... 65L
Capacity weight: ........................................................... 120kg
5. ASSEMBLY
5.1.
Take the wheelbarrow pan and lean it up against a wall or use
an assistant to hold it upon its end.
5.2.
Next attach the frames to the underside of the pan. Ensure
the end of the frame to which the wheel will attach, kicks
outward as in (fig.2).
5.3. Place a frame spacer between the frame and pan over
the pre-drilled holes (fig.1).
5.4. Slide on washers and Insert the bolts through the spacer
and frame and secure with nuts. Repeat for other frame.
NOTE: Only tighten finger tight at this time.
5.5.
Place the pan support between the frame and pan where the two
single drilled hole are, ensure the support is around the
correct way and the kink follows the curve of the pan (fig.1).
5.6. Secure in place by feeding bolt through the pan, support, then
frame and secure with nut.
5.7. Slide the axle sleeve through the centre of the wheel.
5.8. Slide one large washer onto the axle bolt, then insert through the
frame another washer then through the wheel. Slide a washer
onto the axle bolt then though the frame then the last washer and
secure with the axle nut (fig.2).
NOTE: Ensure there is a washer either side of the frame (fig.2).
5.9. Tighten all nuts and bolts, be careful not to over tighten.
© Jack Sealey Limited
WHEELBARROW 65LTR GALVANIZED
MODEL NO:
Wheel assembly
• Wheel
• Axle Bolt
• Axle Nut
• Axle Sleeve
• Large Washer x 4
Original Language Version
WB65
fig.1
fig.2
WB65 Issue 3 (4) 15/07/20