Serial Interface To Dte (X2) - ABB HITACHI EDS500 Series Manual

Connections
Power supply input (X1)
Ripple on DC power supply, IEC 61000-4-17
Conducted emissions - asymetrical DC ports,
common mode (0.15 MHz to 30 MHz), CISPR
16-2-1/ EN 55016-2-1
Pin allocation power supply (X1)
1 2
The device shall be powered off while accessing any of the connectors X1 (power
connector) or X4 (alarm relay). Any other connectors (e.g. RS-232 or 4-wire/2-wire
communication port/X3) are hot-pluggable while the device is operating.
No plug shall be freely accessible in normal operation due to safety reasons.
Due to the internal overvoltage protection, interrupt any connection to ground of the
device for the time of the measurement before you carry out isolation measurements. This
includes the earthing of the hat rail as well as all shields of all transmission lines and supply
feedings. RJ-12 plugs or RJ-45 plugs can also establish earthing via the shield.
4.5.2

Serial interface to DTE (X2)

The RJ-45 connector X2 forms an RS-232-D interface. If the modem is connected to an RTU, an
adapter cable has to be used which connects the pin pairs.
Serial interface to DTE (X2)
Electrical specification
Cable
Plug type
Adapter cable
24
Pin Signal
3
1 24-60 V DC
2 Shield connected to functional earth
3 GND
10% Un
EN 55032/ CISPR 32 class B
W A R N I N G
W A R N I N G
A D V I C E
ITU-T V.24, EIA RS-232, EIA/TIA-561
shielded RS-232 cable, up to 3 m
RJ-45 (8P8C)
500CAB08 1KGT038915R0001: RJ45 to
SubD9F (SWT-RS232), shielded
Device description
1KGT151042 V000 1