Finger Print Sensor Removal - Lenovo Motorola One Zoom Service And Repair Manual

Lenovo Motorola One Zoom
Level 2 – Service and Repair Manual

Finger Print Sensor Removal

NOTE
The Finger Print Sensor can be
recovered and reused after removal.
1. Use the Torque Driver with Torx Bit T3 to
remove the two screws as shown.
/// WARNING ///
The screws cannot be reused after removal.
2. Use the Plastic Tweezer to remove the mylar
from the location as shown.
3. Use the flat end of the Black Stick to open the
Finger Print Sensor ZIF Connector door from
the location as shown.
Use the flat end of the Black Stick to cut the
4.
Finger Print Sensor adhesive as shown.
PAGE 38
Lenovo Confidential Restricted:
Do not share without consent from Lenovo