Table of Contents
Advertisement
2.2.8.2 SD-Card Upgrade Procedure
A6V11164550
Note: In case of SD Card update, the database configuration and system settings
will be lost.
To perform the SD-Card upgrade, the following steps should be taken -:
1. Having written the SD Card, power down the ACC-G2 and insert the SD Card
into the ACC SD-Card slot – removing the dust cover insert first, if fitted.
2. Fit the X120 jumper, which tells the boot loader to boot from the SD Card.
1. Power up the ACC.
2. Wait for it to program – the LEDs will stop blinking after about 30 seconds,
which indicates that programming has completed. If the ACC-G2 was
manufactured before the year 2012, you might need to press the reset switch
between the CPU and Ethernet connector to initiate the upgrade.
3. Power down the ACC-G2 and remove the SD Card and Jumper.
4. Power up the ACC-G2 and check if the new CCP2 platform has been installed.
5. If the ACC-G2 has not been upgraded, repeat the SD-Card Upgrade
Procedure. This may be necessary as some versions of the ACC-G2 have a
single-boot UBOOT installed in them, which requires the SD-Card Upgrade
Procedure to be performed twice for the upgrade to take effect.
Note: Doing an SD Card upgrade will also set the network parameters to the
following default values:
IP Address
Subnet Mask
Ethernet Gateway Address
Host IP Address
Access Controllers
AC5102 (ACC-G2)
192.168.251.1
255.255.255.0
0.0.0.0
0.0.0.0 : 4343
2
17 | 38
Advertisement
Table of Contents
