Table of Contents
Advertisement
Installation
Installation the LNIC-10/100A series 10/100Mbps
PCI bus Fast Ethernet Card requires Hardware
installation
installation.
Step 1, Hardware Installation
Switch off the computer, unplug the power
1.
cord, and remove the computer's cover.
Select an unused PCI bus-master slot and
2.
remove its protective bracket.
Carefully insert the card and press until all
3.
the edge connectors are firmly seated inside
the slot. Then, screw the card's bracket
securely into the PC's chassis.
Install the bracket screw, which secures the
4.
card to the cinouter chassis.
Replace the computer's cover and connect
5.
the network cable to newly installed network
card. Reconnect the computer's power cord
and plug it into the power outlet.
Step 2, BIOS Configuration
Due to a fault in some Plug-n-Play BIOS
programs, it happens occasionally that a newly
installed adapter is assigned an Interrupt Number
which is a lready assigned to another device. In
such a case, the conflict of Interrupt Number will
first,
then
BIOS
5
and
Software
Advertisement
Table of Contents
