Step 1.
Touch the static-protective package that contains the new power supply to any unpainted surface
on the outside of the server. Then, take the power supply out of the package and place it on a
static-protective surface.
Step 2.
If there is a power supply filler installed, remove it.
Figure 50. Hot-swap power supply filler removal
Step 3.
Slide the new hot-swap power supply into the bay until the release latch clicks into place.
Figure 51. Hot-swap power supply installation
Install the air baffle
Use this information to install the air baffle.
"Read the
installation
Guidelines" on
page 46
"Power off
the server
for this task"
on page 90
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 48
.
Chapter 3
Server hardware setup
81