Symbols On The Product - Husqvarna AUTOMOWER 310 Operator's Manual

20. Skid plate
21. Power supply (the appearance of the power supply
may differ depending on market)
22. Loop wire for boundary loop and guide wire
23. Couplers for loop wire
3
24. Stakes
25. Connector for the loop wire
26. Screws for securing the charging station
27. Measurement gauge for help when installing the
boundary wire (the measurement gauge is broken
loose from the box)
28. Operator's Manual and Quick Guide
29. Cable markers
30. Extra blades
31. Low voltage cable
32. Alarm decal

1.6 Symbols on the product

These symbols can be found on the robotic lawnmower.
Study them carefully.
This product conforms to the applicable
EC Directives.
1
Is a part of the Installation kit which is purchased separately.
2
See note 1
3
See note 1
4
See note 1
840 - 001 -
1
2
4
WARNING: Read the user in-
structions before operating
the robotic lawnmower.
WARNING: Operate the disa-
bling device before working
on or lifting the machine.
The robotic lawnmower can
only start when the main
1 and the cor-
switch is set to
rect PIN code has been en-
tered. Turn the main switch to
0 before carrying out any in-
spections and/or mainte-
nance.
WARNING: Keep a safe dis-
tance from the machine when
operating. Keep your hands
and feet away from the rotat-
ing blades.
WARNING: Do not ride on the
machine. Never put your
hands or feet close to or un-
der the machine.
Never use a high-pressure
washer or even running water
to clean the robotic lawnmow-
er.
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 57 and on the
rating plate.
It is not permitted to dispose this product
as normal household waste. Ensure that
the product is recycled in accordance with
local legal requirements.
The chassis contains components which
are sensitive to electrostatic discharge
(ESD). The chassis must also be resealed
in a professional manner. For these
reasons the chassis shall only be opened
by authorized service technicians. A
broken seal can result in the entire or
parts of the guarantee no longer being
valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when trimming
edges where the cables are placed.
Operate the disabling device before you
use or lift the product.
Introduction - 5