Information Messages - Husqvarna AUTOMOWER 310 Operator's Manual

Message Cause
Connectivity problem Potential problem on the connectivity circuit
board in the mower.
Connectivity settings
The connectivity settings was restored due to
restored
a fault.
Poor signal quality
The connectivity circuit board in the mower is
assembled upside down, or the mower itself
is tilted or upside down.

6.3 Information messages

Below a number of information messages are listed which may be shown in the display of the robotic lawnmower.
Contact your local Husqvarna representative if the same message appears often.
Message Cause
Low battery
The robotic lawnmower cannot find the charg-
ing station.
The guide wire is broken or not connected.
The battery is spent.
The charging station's antenna is defective.
Settings restored Confirmation that a
has been carried out.
Guide not found
The guide wire is not connected to the charg-
ing station.
Break in the guide wire.
The guide wire is not connected to the boun-
dary loop.
Guide calibration
The robotic lawnmower has failed to calibrate
failed
the guide wire.
Guide calibration ac-
The robotic lawnmower has succeeded to
complished
calibrate the guide wire.
Difficult finding home
The robotic lawnmower has been following
the boundary wire several laps without finding
the charging station.
840 - 001 -
Reset all user settings
Action
Restart the mower.
If the problem remains, the message requires
action by authorized service technician.
Please check and change the settings if nee-
ded.
Verify the mower is not upside down or tilted.
If not, the message requires action by author-
ized service technician.
Action
Check that the charging station and the guide
wire are installed in accordance with the in-
Installation on page 27 .
structions. See
Find out where the break is and rectify it.
Replace the battery. See
Check if the indicator lamp in the charging
Indicator lamp in the
station flashes red. See
charging station on page 52 .
This is normal. No action required.
Check that the guide wire's connector is tight-
ly connected to the charging station. See
ing and connecting the guide wire on page
18 .
Find out where the break is. Replace the
damaged section of the guide wire with a new
loop wire and splice using an original coupler.
Check that the guide wire is connected cor-
rectly to the boundary loop. See
connecting the guide wire on page 18 .
Check that the guide wires are installed ac-
cording to the instructions, See
the guide wire on page 17 .
No action required.
The installation has not been done correctly.
Plan where to lay the boundary wire on
See
page 13 .
Wrong corridor width setting on boundary
Find charging station on page 29 .
wire. See
The mower was started on a Secondary area
with the Main area setting.
Battery on page 47 .
Lay-
Laying and
Installation of
Troubleshooting - 51