Information Messages - Husqvarna AUTOMOWER 420 Operator's Manual

Message
Zone generator prob-
lem
FlexiFence problem
Cutting system major
imbalance

7.3 Information messages

The list below shows a number of information messages that may be found in the
Connect app. Contact your local Husqvarna representative if the same message appears often.
Message
Low battery
Settings restored
Limited cutting height The cutting height adjustment cannot move.
Unexpected cutting
height adj
Limited cutting height
range
Cutting height prob-
lem
Cutting height
blocked
1201 - 007 - 20.02.2023
Cause
The battery of the FlexiFence accessory is
low. The FlexiFence accessory does not op-
erate when the battery is empty. The product
can cut in the stay-out zone if you start the
product before you charge the FlexiFence
accessory.
The temperature in the FlexiFence accessory
is a higher than the maximum limit and is set
to off.
The product has discovered vibrations in the
blade disc
Cause
The product cannot find the charging station.
The battery is spent.
The charging station's antenna is damaged.
Reset all user settings
Confirmation that a
has been carried out.
Action
Park the product and charge the FlexiFence
accessory before you start the product.
Put the product in an area with protection
from the sun. Let the temperature of the
FlexiFence accessory decrease before you
start the product.
Continued operation can cause damage to
the cutting system. Examine that the blades
and screws are not damaged or worn. Make
sure that all blades are correctly installed and
that there is only one blade attached in each
position on the blade disc.
Messages menu in the Automower
Action
Change the position of the guide wire. Refer
To install the boundary wire on page 19 .
to
Make sure that the installation settings about
how to find the charging station is correct.
To set how the product finds the
Refer to
charging station on page 28 .
Replace the battery. Refer to
page 37 .
Check if the indicator lamp in the charging
station flashes red. Refer to
blades on page 37 . This problem requires
action by authorized service technician.
This is normal. No action required.
Examine the cutting height adjustment and
remove grass or other objects. If the problem
stays, speak to your approved servicing deal-
er.
®
Battery on
To replace the
Troubleshooting - 43