Husqvarna AUTOMOWER 420 Operator's Manual page 15

• Put the charging station in an area with protection
from the sun.
• If the charging station is installed on an island,
make sure to connect the guide wire to the island.
To make an island on page 17 .
Refer to
3.4.2 To examine where to put the power
supply
WARNING:
the low-voltage cable. There is a risk of
electrical shock.
CAUTION:
on the product do not cut the low-voltage
cable.
WARNING:
and extension cable must be outside the
work area to avoid damage to the cables.
CAUTION:
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
• Put the power supply in an area with a roof and
protection from the sun and rain.
• Put the power supply in an area with good airflow.
• Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
power supply to the power outlet.
Low-voltage cables of different lengths are available as
accessories.
1201 - 007 - 20.02.2023
Do not cut or extend
Make sure that the blades
The power supply cable
Do not put the low-voltage
3.4.3 To examine where to put the
boundary wire
CAUTION:
minimum 15 cm / 6 in. in height between
the boundary wire and water bodies, slopes,
precipices or public roads. This will prevent
damage to the product.
CAUTION:
operate on gravel.
CAUTION:
when you install the boundary wire.
CAUTION:
without noise, isolate all obstacles such as
trees, roots and stones.
The boundary wire should be put as a loop around the
work area. Sensors in the product senses when the
product approaches the boundary wire, and the product
selects another direction. All parts of the work area must
be maximum 35 m / 115 ft. from the boundary wire.
To make the connection easier between the guide wire
and the boundary wire, it is recommended to make an
eyelet where the guide wire will be connected. Make the
eyelet with approximately 20 cm / 8 in. of the boundary
wire.
Note:
Make a blueprint of the work area before you
install the boundary wire and guide wire.
There must be a barrier of
Do not let the product
Do not make sharp bends
For careful operation
Installation - 15