Operation; Main Switch; To Start The Product; Operating Modes - Start - Husqvarna AUTOMOWER 420 Operator's Manual

5.1 Main switch

WARNING:
safety chapter before you use the product.
• Set the Main switch to the
product.
• Set the Main switch to the
product to OFF.

5.2 To start the product

1. Push the STOP button to open the hatch on the
product.
2. Set the Main switch to position
3. Enter the PIN code.
4. Push the START button.
5. Select an operating mode. Refer to
modes - Start on page 34 .
6. Push the OK button.
7. Close the hatch on the product.
Note:
If the product is parked in the charging station,
the product will start to operate when the battery is fully
Schedule settings is set for operation.
charged and if the
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.

34 - Operation

5 Operation
Read and understand the
1 position to start the
0 position to set the
1 .
Operating

5.3 Operating modes - Start

Main area
•
Secondary area
•
Override schedule
•
Spot cutting
•
5.3.1 Main area
Use the operating mode
and charge automatically.
5.3.2 Secondary area
Use Secondary area operating mode to cut secondary
areas. You must move the product manually between
the main area and the secondary area. The product cuts
for a selected period of time or until the battery is empty.
Note:
You must put the product manually in the
charging station to charge the product when it is in a
secondary area. The product will move out from the
charging station and stop when the battery is charged.
You must select an operating mode to start the product.
Note:
If you will cut the main area after the battery is
charged, set the product to
put the product in the charging station.
5.3.3 Override schedule
Use the operating mode
temporarily override the
days .
Note:
It is not possible to cut more than the maximum
cutting time for each day. Refer to
suitable operating hours on page 24 .
5.3.4 Spot cutting
Use the operating mode
area in a spiral pattern. You must move the product
manually to the selected area before you start the
cutting operating mode.
Note:
After the product has operated in the operating
Spot cutting , it will automatically start to cut in the
mode
Main area or Secondary area .
operating mode

5.4 To park the product

1. Push the STOP button to open the hatch.
2. Set the Main switch to position 0.
Main area for the product to cut
Main area mode before you
Override schedule to
Schedule settings for 24h or 3
To calculate the
Spot cutting to cut a selected
1201 - 007 - 20.02.2023
Spot