Chapter 10 Options And Peripheral Equipment; Cables/Connector Sets; Combinations Of Connector Sets - Mitsubishi Electric -MR-CV User Manual

10
OPTIONS AND PERIPHERAL EQUIPMENT
Precautions
• HIV wires are recommended to wire the converter unit, options, and peripheral equipment. Therefore, the recommended
wire sizes may differ from those used for the previous generation converter units.
• To prevent an electric shock or a fire, correctly wire options and peripheral equipment, etc. in the correct combination.
10.1

Cables/connector sets

The indicated IP rating is the cable and connector's protection against ingress of dust and water when the
cable and connector are connected to a converter unit. If the IP ratings of the cables, connectors, and
converter units differ, the overall IP rating is determined by the lowest IP rating of all the components.
Purchase the cable and connector options indicated in this section for the MR-CV_ power regeneration converter unit.
If using cables other than the cables described in this manual, comply with the standards and directives applicable to each
country. For example, NFPA 79 in North America demands the use of a listed, certified product that has a thermoset insulator
and is compliant with the NEC standard RHH, RHW, RHW-2, XHH, XHHW, or XHHW-2.
For details on the bus bar, refer to the drive unit/servo amplifier user's manual and instruction manual.

Combinations of connector sets

For the options used to connect to the drive unit, refer to the drive unit manual.
MR-CV_
(1)
No. Product name
(1) Magnetic contactor
wiring connector
(2) Connector set
*1 Crimping tool: 357J-22733 (DDK) is required.
10 OPTIONS AND PERIPHERAL EQUIPMENT
88
10.1 Cables/connector sets
(2)
CN24
CN23
Model Description

MR-CV_ side connector
Connector: 03JFAT-SAXGSA-L (JST)
Open tool
J-FAT-OT-EXL (JST)
MR-CVCN24S MR-CV_ side connector
Connector: DK-2100D-08R
Contact: DK-2RECSLP1-100 (DDK)
*1
Remark
Supplied with
the converter
unit.
