Transmitter Troubleshooting - Nokia 6015 Troubleshooting - Rf

Nokia Customer Care
4. Select the following values on the RF Main Mode dialog box:
Band = PCS (CDMA)
•
Channel = 600
•
Mode = Rx/Tx
•
5. Click Set.
Note: Be sure that the "RF Main Mode set successfully" message appears in the status bar.
6. Open the Troubleshooting menu, point to RF, and click CDMA Control.
The CDMA Control dialog box appears. (See Figure 10 on page 15.)
7. Select the following values on the CDMA Control dialog box.
State = Rho ON
•
Band = PCS
•
Radio Configuration = Mode 1: IS-95 Voice
•
Select the Set default PDM values check box.
•
8. Click Execute.
9. Open the Troubleshooting menu, point to RF, and click PDM Control.
The RF PDM Control dialog box appears. (See Figure 11 on page 16.)
10. Click Read Phone to update the values.
11. Configure the spectrum analyzer using the following values:
• Center Frequency = 1880 MHz
• Span = 100 MHz
• Amplitude = 20 dBm
• Attenuation = Auto
• BW = Auto

Transmitter Troubleshooting

After Phoenix is set up using either the AMPS, Cell, or PCS setup procedures, use the
following steps to troubleshoot the transmitter.
1. Use a voltmeter to verify that the VR2, VR6, and VR1B are on the transmit
system. (See Figure 13 on page 19 and Figure 14 on page 20).
• If any are missing, look for SMD problems around Jupiter and the UEM.
• If the SMD is good, replace the UEM.
Issue 1 08/2004
6015/6015i/6016i/6019i (RH-55), 6012 (RM-20)
©2004 Nokia Corporation
Troubleshooting - RF
Company Confidential Page 17