Getting Started; Charging The Battery; Turning Your Headset On; Turning Your Headset Off - Silvercrest HS 2700 BT User Manual

English
5

GETTING STARTED

Charging the Battery

The headset comes with a built-in rechargeable battery. For first time use, it takes about 4
hours to fully charge the battery. Afterwards, it will take approx. 2 hours to become fully
charged. With the battery fully charged, the talk time is up to 4,5 hours, and the standby time
is up to 100 hours.
Battery Indicator
The red LED indicator on the headset will flash slowly when the battery is low. Recharge the
battery when the red LED indicator on the headset starts flashing or when you hear a recurring
warning tone.
To Charge the Battery
1. Connect the charger to a wall outlet.
2. Connect the adapter to the charger and to the headset as shown in the above picture. The
red and green LED indicators on the adapter will light up.
3. When the battery is fully charged, the red LED indicator on the adapter will go out.
NOTE:
The headset will turn itself off while charging the battery. Remember to turn it back on
once the battery is fully charged.

Turning Your Headset On

1. Put the headset on.
2. To turn the headset on, press and hold the S1 button for about 3 seconds until you hear two
short beeps. The blue LED indicator on the headset flashes.

Turning Your Headset Off

1. To turn the headset off, press and hold the S1 button for 3 seconds. After that you will hear
two tones and the red LED indicator on the headset flashes quickly. The headset is then
powered off.

Pairing the Headset

You are required to pair the headset with your Bluetooth mobile phone before using it.
English
6