Advertisement
Available languages
Available languages
E N G L I S H
Voltage
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
DI-switch (in-line protector PRCD)
The machine is equipped with a residual current
device (RCD), which protects the user against
electric shock by interrupting the circuit when a
leakage current of 10 mA or greater is detected.
For 115 V units the rated leakage current is 6 mA.
Never operate the machine without the
!
RCD in place. Do not use the machine
if the RCD does not function properly.
For the RCD to work, the machine must
be connected to an earthed wall socket.
To switch on the RCD:
● I = ON (red LED lights up).
● Switch on the machine (also refer to the section
"Switching on and off").
● To switch OFF, proceed in reverse order.
To test the RCD:
● O = Test button: the switch must break the
circuit (machine switches off).
● If in the test mode the switch does not
!
break the circuit, we recommend that
the unit is inspected by an authorized
D
WALT repair agent.
E
● It is not permitted to make any
modifications to the machine, in
particular it is not allowed to open the
PRCD or to repair or replace the cable.
● Never use the PRCD as a main switch.
Always switch the PRCD under no load
condition.
Assembly and adjustment
Prior to assembly and adjustment
@
always unplug the tool.
30
Amperes Cable rating (Amperes)
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Fitting the drill to the stand (fig. B)
The machine has to be fitted to the D215851 stand
6
6
by means of the mounting bracket supplied with
6
6
the stand.
15
15
+
20
-
● Fit the mounting bracket to the base of the
machine.
● Carefully place the machine with the bracket
into the bracket holder on the stand as shown.
● Secure the machine to the stand by tightening
the bolt with the feed handle.
@
Mounting and removing an accessory (fig. C)
This tool uses threaded core bits and adaptors
which thread directly onto the spindle (4).
We recommend to use professional accessories
only.
● Choose the appropriate core bit for wet drilling.
● Follow the core bit or manufacturer's
recommendations for mounting the accessory.
You may require an adaptor to fit the bit onto
the spindle.
● Make sure to place a copper ring (25) between
the spindle and the core bit to facilitate removal
of the core bit after use.
● Hold the spindle using the open-ended wrench
(20) and tighten the core bit (21) by rotating
clockwise using the open-ended wrench (22).
@
Three gear selector (fig. A)
The tool is fitted with a three gear selector (3) to
vary the speed/torque ratio.
● Release the switch and select the required
position after the motor has come to a complete
standstill.
● Always align the selector with the marks on the
gear housing.
● Refer to the technical data to choose the
appropriate gear according to the diameter of
the core bit and the material to be drilled.
Also refer to the drill stand manual.
Always mount your drill firmly to prevent
movement.
Make sure the entire assembly is tight
before starting the operation.
Advertisement
