Network - D-Link DAP-3712 User Manual

Section 3 - Configuration

Network

In the Network tab, you can set up the DAP-3712's network mode and IP address.
Network Mode: Select either Bridge Mode or Router Mode.
Bridge Mode: In this mode, the DAP-3712's LAN Port and Wi-Fi
will bridge together.
Router Mode: In this mode, the DAP-3712 will act as a router.
Management Use this to set up a management VLAN ID tag and
VLAN: IP address. When the VLAN is enabled, the DAP-
3712 can only be accessed with this VLAN tag and
IP address.
In Bridge Mode, users can configure the DAP-3712's LAN interface.
IP Protocol:
Use this setting to select either Static IP or DHCP IP.
IPv4/IPv6
Enabling this function in bridge mode is not
DHCP Server:
recommended. When you enable this function,
you need to make sure there are no DHCP servers
in the DAP-3712's network.
In Router Mode, you need to configure the LAN and WAN interface
of the DAP-3712.
LAN interface:
You can set the IP addresses of the devices which
can be accessed via Wi-Fi using this setting.
WAN Interface:
In router mode, the physical LAN port becomes
the WAN port. You need to enter the IP address
or configure DHCP clients to get the IP address as
well as PPPoE.
D-Link DAP-3712 User Manual 29