Table of Contents
Advertisement
1. COVER REMOVAL
The camera's cover must be removed prior to
adjustment for LED brightness or setting the
camera's lens angle. The set-screw located at
the bottom of the cover casting is not tightened
at the factory and protrudes by 1/8" (3mm) in
order for the cover to be easily rotated.
Make sure the O-Ring gasket at the base of the
threads is not damaged or dislodged during the
cover's removal process.
Refer to Figure 1 – 1.
Step 1.1 -
Step 1.2 -
Step 1.3 -
Place the camera casting assembly
on a flat surface.
Firmly hold the base with one hand
and rotate the cover in a counter-
clockwise direction with the other
hand. Do not use a screwdriver or
other metal device during this
procedure.
Remove the cover and set it aside in
a safe place.
4
Advertisement
Table of Contents
