Advertisement
4. OpERATION
WARNING! Measure the outer diameter of the spring to be compressed and select the correct set of jaws.
‰
IMpORTANT! DO NOT start by using the coil spring compressor fully extended, but adjusted to a length of approx. 200mm. this will
ensure adequate travel to fully expand and compress the spring regardless of the initial spring tension.
4.1.
Ensure that the coil spring to be compressed is free from dirt and grease where the jaws will be in contact with it.
4.2.
Jack up the vehicle to remove the coil spring. Ensure that the vehicle is safely and properly supported.
4.3.
Insert the jaw (FIG.2-A) into the lower spring windings.
4.4.
Insert jaw (FIG.2-B) into the upper spring windings. Ensure that the spring windings sit between the inner and outer rims of the jaw.
4.5.
Insert the main body of the spring compressor into the inside of the spring from below with the hexagonal drive nut facing downwards.
Guide compressor through the lower jaw and up into the upper jaw, when the compressor has passed through the upper jaw turn the
body through approx 50° so it locates in the locking grooves on the jaw FIG.3.
4.6.
Using a 19mm hex socket, begin to turn the hexagonal drive nut until the jaws are firmly in contact with the spring.
4.7.
Before proceeding ensure that the spring is correctly placed within both jaws and jaws are correctly aligned on the compressor body.
4.8.
now continue compress the spring.
WARNING! An air wrench must not be used. Use of air wrench will invalidate warranty.
‰
WARNING! Spring compression MuST cEASE bEFORE the windings touch. DO NOT allow the compressor to reach the limit of its
‰
travel in either direction.
4.9.
Remove the spring and compressor assembly from the vehicle as soon as you have attained sufficient compression.
4.10.
With the spring adequately supported drive the compressor in the opposite direction and remove the compressor and jaws from the
spring.
4.11.
to re-mount the spring back in the wishbone assembly, reverse the compress procedure.
A
5.
MAINTENANcE
5.1.
Before each use check the compressor to ensure it is not damaged or worn.
5.2.
If suspect, do not use the unit, but contact your Sealey stockist who will be able to advise you regarding repair kits and spare parts.
5.3.
Grease the compressor spindle as necessary, at least every six months using graphite grease.
5.4.
Keep the compressor clean, and when not in use store in a safe, dry, childproof location.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Fig.2
b
Environmental protection
Fig.3
Advertisement
