Brother MFC-P2500 User Manual page 128

APPENDIX
IMPORTANT - Wiring Information (For U.K. only)
If the power cord supplied with this printer is not suitable for your electrical outlet,
remove the plug from the mains cord and fit an appropriate three pin plug. If the
replacement plug is intended to take a fuse then fit a fuse with the same rating as the
original.
If a moulded plug is severed from the power cord then it should be destroyed because a
plug with cut wires is dangerous if plugged into a live socket outlet. Do not leave it
where a child might find it.
In the event of replacing the plug fuse, fit a fuse approved by ASTA to BS1362 with
the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE PROPERLY EARTHED.
The wires in the mains cord are coloured in accordance with the following code:
The colours of the wiring in the power lead of this printer may not correspond with the
markings which identify the terminals in your plug. If you need to fit a different plug,
proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the coloured
insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction of the plug
permits, leave the green and yellow wire longer than the others so that, in the event that
the cord is pulled out of the plug, the green and yellow wire will be the last to
disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the terminal in the
plug which is marked with the letter "E" or by the earth symbol or coloured green or
green and yellow.
Green and yellow:
Blue:
Brown:
Ground
Neutral
Live
vii