How To Apply An Emergency Power; How To Replace Batteries - Philips EasyKey User Manual

Push-pull smart door lock
Hide thumbs Also See for EasyKey:
Table of Contents

Advertisement

Anti-dismantle alarm
Triggering 1: The door is pried open and the sensor
latch bolt pops up.
Alarm mode: Continuous repeated alarms.
Turning off: The
automatically or by a successful verification.
Triggering 2: Outside escutcheon is pried open
and there is no fit to the door.
Alarm mode: Continuous repeated alarms.
Turning
successful key verification, or close after the
normal indoor unlock.
Deadbolt abnormity alarm
24
alarm
can
be
turned
off:
Auto-close,
or
close
after
Triggering: The deadbolt works abnormally.
The door cannot be locked or unlocked.
Alarm mode: Continuous repeated alarms.
Turning off: The alarm will be automatically
turned off.

How to apply an emergency power

off
a

How to replace batteries

When the battery voltage is insufficient, and
the door cannot be opened from the outside,
you can power the lock through the Micro
USB interface by using a 5V power bank as
an emergency power supply. After opening
the door lock, please replace the batteries
immediately.
Emergency
power interface
The lock is powered by four 1.5V alkaline
batteries. There are two sets of working
power inside the battery case. Eight
batteries can be put in to extend the
battery life and reduce battery replacement
frequency. The battery cabinet is located
at the upper end of the inside escutcheon.
By pushing the battery cover upwards, you
can remove the battery cover and then the
batteries.
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

9100Easykey 9100

Table of Contents