Part Names; Outside Of The Machine; Inside Of The Machine - Brother LX-900 Owner's Manual

Part names

Outside of the machine

DC connector
Top cover
Viewing window
Document tray
Document supporter
Document guide
Control panel
Document output
Corner cutter slot
Corner cutter tray
Corner cutter dust box
AC adapter

Inside of the machine

Film cartridge
Roller release lever
Roller holder lock button
Roller holder
Side cutter arm
Side cutter units
Top/bottom cutter units
Roller
Document guide
DC connector
Located on the left, backside of the machine. Aperture for the AC
adapter.
For replacing the film cartridge and cutter units.
Located on the top cover. Allows you to make sure that the
correct type of film cartridge is loaded into the machine.
Where documents to be laminated are placed.
Supports the document for insertion.
Aligns the left edge of the paper for proper document insertion.
Power switch and function button area.
Location where the document exits the machine.
Allows you to trim the corners of your document after laminating.
Corners of a document are automatically trimmed after insertion
into the corner cutter slot.
The corner of your laminated document is placed on this tray to
position it into the corner cutter slot.
Collects trimmings from the corner cutter.
Plugs into an electrical outlet and the DC connector on the
machine.
Contains the roll film. The label on the cartridge identifies the film
type.
You can use 9.0 inch (A4) or 4.8 inch (A6) width LC cartridges
with this machine.
Releases the roller.
Locks the roller holder.
Holds the roller unit.
Arm for the side (vertical) cutter unit.
Blades for side (vertical) cutting.
Blades for top/bottom (horizontal) cutting.
Feeds the document into the unit.
Document supporter
Document tray
Viewing window
Control Panel
Corner cutter dust box
Document output
Top cover
Corner cutter slot
Top/bottom cutter unit
- 7 -
Side cutter arm
Film cartridge
Roller holder
Roller release
lever
Roller
Side cutter
unit
Roller holder
lock button