Sealey AK7160 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
‰
WARNING! Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
‰
This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer's manual.
9
Ensure that the kit is correct for the task.
9
Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey stockist.
9
DO NOT use the kit for any purpose other than that for which it is designed.
8
Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9
Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey stockist.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
DO NOT use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
8
After use, store in a safe, dry childproof area.
9
2. INTRODUCTION
Screw type bridge extractor set. The thin tapered lips on the collets secure a positive grip on the curved surface of the internal bearing bore.
Gently removes blind bearings where the use of a slide hammer may damage the surrounding material. Bearing extractor collets with internal
capacity from 8 to 27mm.
3. SPECIFICATION
Model No:. ................................................................ AK7160
Collet diameter:
8-9.4, 9.5-11.4, 11.5-13.4, 13.5-16.4, 16.5-18.4, 18.5-24, 24.5-29.5mm
4. CONTENTS
Refer to attached Parts List
© Jack Sealey Limited
BEARING PULLER SET 10PC
MODEL NO:
Wear protective
gloves
Original Language Version
AK7160
AK7160 | Issue 1 09/01/20