Sealey AK716.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this tool.
‰
WARNING! Familiarise yourself with the specific applications and limitations of the kit, as well as any potential hazards.
‰
This kit should be used in conjunction with inspection maintenance procedures recommended in the vehicle manufacturer's manual.
9
Ensure that the kit is correct for the task.
9
Wear the appropriate personal protective equipment for the task. A full range is available from your Sealey stockist.
9
DO NOT use the kit for any purpose other than that for which it is designed.
8
Ensure that the vehicle is properly supported with axle stands before working under the vehicle.
9
Ensure there is adequate lighting prior to using the kit. A range of inspection lamps are available from your Sealey stockist.
9
Keep children and unauthorised persons away from the working area.
9
DO NOT use the kit if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
DO NOT use the kit when you are tired, or under the influence of alcohol, drugs or intoxicating medication.
8
After use, store in a safe, dry childproof area.
9
2. INTRODUCTION
Medium stroke 1.5kg slide hammer with 395mm shaft and a screw-type bridge extractor. Gently removes blind bearings where the use of a
slide hammer may damage the surrounding material. Includes bearing extractor collets with internal capacity from 8-34mm.
3. SPECIFICATION
Model No:. .............................................................AK716.V2
Collet Ø:
Ø8-9.5, 10-11.5, 12-13.5, 15-16, 17-18.5, 20-23, 24.5-27, 30-32, 32-34mm.
4. CONTENTS
No. Part no. Description
1 AK716.V2-01 Slide hammer
2 AK716.V2-02 Collet 20-23mm + drive pin 13mm (long)
3 AK716.V2-03 Collet 8-9.5mm + drive pin 13mm (short)
4 AK716.V2-04 Collet 10-11.5mm + drive pin 10mm
5 AK716.V2-05 Collet 12-13.5mm
6 AK716.V2-06 Collet 15-16mm
7 AK716.V2-07 Collet 17-18.5mm
8 AK716.V2-08 Collet 24.5-27mm
9 AK716.V2-09 Collet 30-32mm
10 AK716.V2-10 Collet 32-34mm
11 AK716.V2-10 Drive pin 13mm
12 AK716.V2-12 Puller assembly
13 AK716.V2-13 Drive pin 5mm
© Jack Sealey Limited
12PC BLIND BEARING PULLER SET
MODEL NO:
Wear protective
gloves
Original Language Version
AK716.V2
AK716.V2 Issue 4 (3) 10/03/22