Sealey AK714.V3 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to the instruction manual
1. SAFETY
WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are adhered to when using

this product.
DO NOT use this product if damaged.

Maintain product in good and clean condition for best and safest performance.

If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and chocks.

Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.

Wear suitable clothing to avoid snagging. DO NOT wear loose jewellery and tie back long hair.

Account for all tools and parts being used.

If working off the vehicle, secure the work piece in a vice or clamp it to a work bench.

DO NOT operate puller if you are tired or under the influence of alcohol, drugs or intoxicating medication.

IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to establish the current

procedure and data. These instructions are provided as a guide only.
2. INTRODUCTION
2.1. Introduction
Fully chromed carbon steel medium stroke slide hammer. 380mm Overall length with 0.9kg hammer. Bearing extractor collets with internal
capacity from 12 to 32mm. Supplied in carry-case.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . AK714.V3
Collet Sizes Ø:.. . . . . . . . . . . . . 12-16.5mm
. . . . . . . . . . . . . . . . . . . . . . . . . 16.5-18mm
. . . . . . . . . . . . . . . . . . . . . . . . . 18-24.5mm
. . . . . . . . . . . . . . . . . . . . . . . . . 24.5-32mm
4. CONTENTS
24.5mm - 32mm Attachment (Part No: AK714.V3-01)
18mm - 24.5mm Attachment (Part No: AK714.V3-02)
Slide hammer
16.5mm - 18mm Attachment (Part No: AK714.V3-04)
12mm - 16.5mm Attachment (Part No: AK714.V3-05)
© Jack Sealey Limited
INSTRUCTIONS FOR:
BLIND BEARING PULLER SET - 5PC
MODEL NO:
Wear eye protection
(Part No: AK714.V3-03)
Original Language Version
AK714.V3
AK714.V3 Issue: 1 - 26/08/15