Advertisement
3.
OPERATING INSTRUCTIONS
3.1.
Prepare Wheel Bearing for Removal (fig.1)
3.1.1. remove the motorcycle wheel, using the method
described in the motorcycle manufacturer's service
instructions, or a proprietary manual.
3.1.2. If fitted, remove the retaining circlip. A range of circlip
pliers suitable for this task are available from your
sealey dealer.
3.1.3. remove the hub bearing seal. It is always advisable to
replace the seal with a new item after it has been
removed.
3.3.
Insert Drift into Collet (fig.3)
3.3.1. locate the tapered end of the corresponding sized drift
into the allocated slot in the collet.
3.3.2. Using a suitable hammer, strike the drift firmly into the
allocated slot in the collet. this will expand the collet,
binding it to the inner race of the wheel bearing.
Parts support is available for this product. To obtain a
parts listing and/or diagram, please log on to
www.sealey.co.uk, email sales@sealey.co.uk or phone
01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey limited 2012
fig.1
3.2.
3.2.1. Select the correct sized (closest fitting) collet and insert
3.2.2. With the collet inserted, place the wheel, with the collet
3.2.3. the allocated slot in the collet should be visible through
fig.3
3.4.
3.4.1. Support the wheel and hub, leaving sufficient clearance
3.4.2. using a suitable hammer, strike the drift to remove the
3.4.3. once the wheel bearing and collet have been
3.4.4. Grip the drift in a vice and detach the wheel bearing
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk,
IP32 7Ar
Original Language Version
Insert Collet (fig.2)
it into centre of the wheel bearing.
lowermost on a firm, solid surface.
the hub.
Remove Wheel Bearing (fig.4)
so that the collet and wheel bearing can be driven out
of the hub. ensure that the hub and wheel are supported
sufficiently, so that no damage will be inflicted to the
brake discs, hub or wheel rim as a result of removing
the wheel bearing.
wheel bearing and collet from the hub.
extracted, remove by passing the drift through the hub.
and collet carefully using a hammer. remove the collet
from the wheel bearing and return all items from the
wheel bearing removal kit back to the case.
01284 757500
01284 703534
fig.2
fig.4
www.sealey.co.uk
Web
sales@sealey.co.uk
email
Ms062
Issue: 1 - 26/06/12
Advertisement
