AEG AHB520E1LW User Manual page 34

34 www.aeg.com
Problem
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after press‐
ing the SUPER, or after
changing the temperature.
The temperature in the appli‐
ance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incorrect‐
ly.
Large quantities of food to
be frozen were inserted at
the same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed proper‐
ly.
The SUPER function is
switched on.
The lid is not closed properly
or the gasket is deformed/
dirty.
Temperature is set incorrect‐
ly.
This is normal, no error has
occurred.
The temperature regulator is
not set correctly.
The lid is not closed proper‐
ly.
The products' temperature is
too high.
Many products are stored at
the same time.
Solution
Contact the Authorised
Service Center to replace
the LED light.
Refer to "Control panel/
Temperature regulation"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to the climate class
chart on the rating plate or
to the "Installation/Position‐
ing" chapter.
Allow food to cool to room
temperature before storing.
Check if the lid closes prop‐
erly and the gaskets are not
damaged or dirty.
Refer to "Control panel/SU‐
PER function" chapter.
Check if the lid closes prop‐
erly and the gaskets are not
damaged or dirty.
Refer to "Control panel/
Temperature regulation"
chapter.
The compressor starts after
a period of time.
Set a higher/lower tempera‐
ture.
Check if the lid closes prop‐
erly and the gaskets are not
damaged or dirty.
Allow food to cool to room
temperature before storing.
Store less products at the
same time.