Sealey Worksafe SSP78.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
This face shield is designed for face and eye protection against high speed particles of low energy impact. The visor is designed to
9
be lightweight and comfortable to wear.
The product protects against high speed particles worn over standard ophthalmic spectacles, but may transmit impacts, thus creating
9
a hazard to the wearer.
Avoid liquids as small particles can splash into the eyes.
9
Inspect the face shield frequently as a pitted or scratched face shield reduces vision and should be replaced immediately.
9
When necessary, use identical replacement parts contact your Sealey stockist.
9
DO NOT use if any part of the face shield is cracked or broken.
8
DO NOT place this product on a hot surface.
8
DO NOT use this face shield for protection against short circuit electric spark, fine dust, gas, ultra violet or infra red radiation,
8
ionising radiation, liquids under pressure or other severe hazards.
DO NOT use this face shield against heavy impact hazards.
8
DO NOT use this face shield for welding.
8
2. INTRODUCTION
Ratchet adjustable headband with brushed nylon comfort band. Competitive quality for automotive, agricultural and industrial applications.
Can be used with standard glasses. Conforms to EN 166, Optical class 1,Impact grade F.
3. SPECIFICATION
MODEL NO: ......................................................... SSP78.V2
Consumable Parts: ............ SSP78.V2R - Replacement Visor
Lens Type: .................................................................... Clear
4. ADJUSTING THE MASK
4.1. ADJUSTING THE FIT OF THE HELMET (SEE FIG.1)
4.1.1. The circumference of the headband is adjusted by turning
the wheel on the rear.
4.1.2. The two top straps can also be adjusted by releasing the
pin from the top strap and adjusting as required.
4.1.3. The distance between the headband assembly and
the helmet can be adjusted by undoing the external
thumbwheels both sides and sliding the headband
assembly forwards or backwards, as required. Re-tighten
the thumbwheels. (See figs.1 and 2.)
4.1.4. Test the fit of the helmet by lifting it up and closing it a few
times whilst wearing it. If the headband moves whilst tilting,
readjust it until it is stable.
fig.2
© Jack Sealey Limited
DELUXE BROW GUARD WITH ASPHERICAL
POLYCARBONATE FULL FACE SHIELD
SSP78.V2, SSP78.V2R
MODEL NO:
fig.1
Original Language Version SSP78.V2, SSP78.V2R Issue 2 02/11/2020