I/O Allocation; General; Digital Values And Control Flags - Panasonic FP7 User Manual

Analog output unit

Hide thumbs Also See for FP7:

Table of Contents

Chapter 3

P r o c e d u r e

R e f e r e n c e

FP7 Analog Output Unit User's Manual

Each unit attached to the CPU must be configured in an I/O map which is

registered in the CPU. The current I/O map can be displayed in the "I/O

map and unit configuration" dialog. It shows the slot numbers and starting

word numbers of the CPU and its expansion units. I/O addresses are allo-

cated based on the starting word number.

To display the current I/O map and starting word number of a unit in Con-

trol FPWIN Pro, proceed as follows:

1. Open project

2. Double-click "PLC" in the navigator

3. Double-click "I/O map and unit configuration"

4. Double-click the desired slot number

Please refer to the CPU Hardware User's Manual for details on entering

and uploading I/O maps.

Before D/A conversion, the digital input values to the analog unit are writ-

ten to the CPU's output area (WY). Control flags are also allocated to the

CPU's outputs.

The I/O addresses in the table show offset addresses. I/O addresses actu-

ally allocated are based on the first word number allocated to the unit.

Example: If the first word number is 10, the address number for the digital

input value on channel 0 will be WY10.

I/O allocation

Table of Contents

Afp7da4h