Filling The Water Tank; Before First Use - Silvercrest SDBS 2400 B2 Operating Instructions Manual

Filling the water tank

NOTE
Use only tap water or distilled water.
If the mains water in your location is rated as hard, it is recommended that you
mix the mains water with some distilled water. Otherwise limescale deposits
can adversely affect the appliance functions.
Mix the tap water with distilled water as described in the table below:
Do not add water with any additives (such as starch, perfume, softeners or
other chemicals) to the water tank
residues can form in the steam chamber. The residues could contaminate the
clothing if they come out of the steam outlets.
♦ Pull the water tank
♦ Fill the water tank
Do not fill above the MAX marking in the water tank
♦ Push the water tank
NOTE
► Do not tip or swivel the appliance when the water tank
Otherwise, water could drip from the filler opening
Before first use
♦ Clean the sole of the iron
♦ To remove any production residues, iron several times over an old, clean
cloth. Press the steam button
SDBS 2400 B2
Water hardness
very soft/soft
medium
hard
very hard
by the grip
with tap water via the filler opening
back into the base station
using a slightly moist cloth.
Ratio of distilled water to
tap water
-
1:1
2:1
3:1
. These could damage the appliance as
out of the base station
until it clicks into place.
.
a few times.
.
.
.
is full.
GB │ MT │
77 ■