Advertisement
Available languages
Available languages
EURO • Printed in England • BA F 016 L69 797 • ARM 320 • GB • OSW 11/00
F 016 L69 797.book Seite 5 Dienstag, 21. November 2000 7:52 07
Fault Finding
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem contact your service agent.
Warning: Switch off, remove plug from mains before investigating fault.
Symptom
Machine fails to operate
Machine functions
intermittently
Machine leaves ragged fi-
nish
or
motor labours
Cutting blades not rotating Cutting blade obstructed
Excessive vibration/noise
Guarantee
We guarantee Bosch appliances in accordance with
statutory/country-specific regulations (proof of pur-
chase by invoice or delivery note).
Damage attributable to normal wear and tear, over-
load or improper handling will be excluded from the
guarantee.
In case of complaint please send the machine, un-
dismantled, to your dealer or the Bosch Service
Centre for lawn and garden products.
F016 L69 797 • 11.00
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Mower in long grass
Extension cable damaged
Machines internal wiring damaged
Height of cut too low
Cutting blades blunt
Underside of machine badly clogged
Blade fitted upside down
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade and/or fan damaged
When the time comes to dispose of this product
please consider the environment and take it to a rec-
ognized recycling facility (please contact your local
authority for location information).
English - 5
Remedy
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Increase height of cut and tilt mower.
Inspect cable, replace if damaged
Contact Service Agent
Increase height of cut
(see "Height of Cut Adjustment")
Replace blades
(see "Blade Maintenance")
Clean machine
(see "After Mowing/Storage")
Refit blade correctly
(see "Blade Maintenance")
Clear obstruction
Tighten blade nut/bolt
Tighten blade nut/bolt
Replace blade and/or fan
Environmental Protection
The machine minimizes environmen-
tal impact because it runs at a low
noise level.
The machine has been assembled in
an environmentally responsible way.
Recycle raw materials instead of
disposing as waste.
Machine, accessories and packaging
should be sorted for environment-
friendly recycling.
These instructions are printed on re-
cycled paper manufactured without
chlorine.
The plastic components are labelled
for categorized recycling.
Advertisement
