3. Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
❶ Turning on the Projector
NOTE:
• The projector has two power switches: a main power switch and a POWER (
• When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed to the off ( ) po-
sition. Failure to do so may cause damage to the projector.
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
•
The projector will go into standby mode. When in
standby mode, the POWER indicator will light orange
and the STATUS indicator will light green to show that
[Normal] mode is selected for [Standby mode].
2. Remove the lens cover.
3. Press the POWER (
net or the POWER (
for about 1 second.
The STATUS indicator goes off and the POWER indica-
tor starts blinking.
When the POWER indicator turns a steady green, and
the projector is ready to use.
TIP: When the STATUS indicator lights orange, it means that
the [Key lock] is turned on. See page 60.
• When the message "Projector is locked! Enter your password."
is displayed, it means that the [Password] is turned on. See
page 38.
After you turn on your projector, ensure that the com-
puter or video source is turned on and that your lens
cover is removed.
) button on the projector cabi-
) button on the remote control
) button.
Standby
Steady orange
light
See page
72
for more details.
POWER
INFO.
IMAGE
INPUT
AUTO PC
ASPECT
BLANK
MENU
Blinking
Power On
Blinking
Steady
green light
green light