Sealey RE89 Quick Start Manual

Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear safety
instructions
footwear
1. safeTy
ensure the trolley is in sound condition and good working order. Take action for immediate repair or replacement of damaged parts.
9
Use genuine parts only. The use of improper parts may be dangerous and will invalidate the warranty.
WarnInG! Prepare the vehicle ready for resting and moving on the trolley. ensure the vehicle will not move, tip, fall etc
‰
once it has been seated on the trolley. Take any necessary precautions to protect persons, property and equipment when using this
trolley.
locate the trolley in a suitable, well lit working area.
9
Keep working area clean and tidy and free from unrelated materials.
9
Use trolley on level and solid ground, preferably concrete. Avoid
9
tarmacadam as trolley may sink in.
ensure the vehicle engine is switched off .
9
9 ensure there are no passengers in the vehicle.
ensure all non-essential persons keep a safe distance whilst the
9
trolley is in use.
9
only place trolley under those lifting points recommended by vehicle
9
manufacturer (see vehicle hand book).
Check the lifting point is stable and correctly held in trolley supports.
9
ensure the trolley wheels are free to move and that there are no
9
obstructions.
ensure you have a clear view and necessary assistance when
9
transporting vehicle.
ensure there are no persons or obstructions beneath the vehicle before moving.
9
When stationary, always lock the two brake wheels.
9
Do noT operate the trolley if damaged.
8
Do noT allow untrained persons to operate the trolley.
8
Do noT exceed the rated capacity of the trolley.
8
WarnInG! Do noT use the trolley to hold and move a vehicle which is unstable.
‰
Do noT allow the vehicle to move on the trolley.
8
Do noT move vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substances.
8
Do noT work under the vehicle unless supported by axle stands which have been correctly positioned.
8
Do noT ride on the trolley.
8
Do noT use the trolley without appropriate supports.
8
Do noT use the trolley for purposes other than which it is intended.
8
When not in use store trolley in a safe, dry, childproof area.
9
2. InTroDucTIon
Steel frame designed for supporting and moving partly dismantled or badly damaged vehicles around the workshop or bodyshop.
Sliding castor brackets adjust for width and rubber-faced support pads adjust for height.
3. specIfIcaTIons
Model no:..................................................................... re89
Capacity: .................................................................... 2000kg
min. height: ................................................................ 300mm
max. height: ............................................................... 390mm
max. width: ............................................................... 1485mm
Castor diameter ...................................................... Ø150mm
© Jack Sealey limited
2Tonne TransporTacar Trolley
model no:
Wear safety
gloves
Original Language Version
re89
fig.1
Re89 Issue 1 07/05/19