Download Print this page
Sealey ROADSTART RS1200TI Manual
Sealey ROADSTART RS1200TI Manual

Sealey ROADSTART RS1200TI Manual

1200a 12v jump starter & tyre inflator

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instruction
protection
manual
1.
SAFETY
IMPORTANT WARRANTY INFORMATION: KEEP YOUR ROADSTART HEALTHY
Read and understand the general safety and operating instructions before use. The following information is intended to help you
9
keep the product in top working order.
NOTE: – The battery in this unit is a consumable item and its ability to accept charge will reduce over time. We will provide warranty
against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not charged properly before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we
will not replace the battery even if it is less than one year old.
You can help prolong the life of the battery by following a few simple guidelines.
9
Plug in your new Roadstart via the Type - C connection to USB and make an INITIAL charge.
9
Ensure the unit is fully charged before storage.
9
DO NOT leave the Roadstart for longer than 2 months without putting it on charge.
8
DO NOT attempt to start a vehicle when the Roadstart battery level lights show red.
8
DO NOT drop or roughly handle the Roadstart.
8
IMPORTANT: To reduce the risk of a battery explosion, follow these instructions and those published by the battery manufacturer
and the manufacturer of any equipment you intend to use in the vicinity of the battery. Remember to review warning marks on all
products and on engines. Modern vehicles contain extensive electronic systems. Check with the vehicle manufacturer for
any specific instructions regarding the use of this type of equipment on each vehicle. No liability will be accepted for damage/injury
where this product is not used in accordance with all instructions.
1.1.
PERSONAL PRECAUTIONS
Ensure there is another person within hearing range, or close enough to come to your aid should a problem arise, when working
9
near a lead-acid battery.
Have fresh water and soap nearby in case battery acid contacts skin, clothing or eyes.
9
Wear safety eye protection and protective clothing. Avoid touching eyes while working with a battery.
9
Wash immediately with soap and water if battery acid contacts skin or clothing. If acid enters eye, flush eye immediately with cool,
9
clean running water for at least 15 minutes and seek immediate medical attention.
Remove personal metallic items such as rings, bracelets, necklaces and watches. A lead-acid battery can produce a short-circuit
9
current high enough to weld a ring or the like to metal, which may cause severe burns.
1.2.
IMPORTANT SAFETY INSTRUCTIONS
Familiarise yourself with the applications, limitations and potential hazards of the RoadStart.
9
Keep the unit in good working order and condition. Replace damaged parts immediately.
9
The RoadStart must only be opened and checked by qualified service personnel. DO NOT disassemble the unit for any reason.
9
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.
9
If the RoadStart receives a sharp knock or blow, it must be checked by a qualified service agent before being used.
9
When not in use re-charge every two months.
9
DO NOT smoke or allow a spark or flame in the vicinity of the battery or engine.
8
DO NOT drop any metal item onto the battery as it may spark or short circuit the battery, which could cause an explosion.
8
DO NOT use RoadStart to recharge dry cell batteries that are commonly used with home appliances. These batteries may explode
8
and cause personal injury and damage to property.
DO NOT charge or boost a frozen battery.
8
DO NOT use attachments other than those recommended. To do so may risk damage to the unit and other equipment and possible
8
personal injury.
DO NOT pull or carry the unit by its cables and DO NOT pull the negative and positive clamps from the battery terminals.
8
DO NOT operate in vicinity of flammable liquids or gases.
8
DO NOT recharge the unit with plugs, cables or attachments that are damaged. Replace such items immediately.
8
DO NOT use this product to perform a task for which it is not designed.
8
DO NOT store the unit in damp or wet locations or where the temperature may exceed 50°C.
8
DO NOT submerge the unit in water.
8
DO NOT use whilst under the influence of drugs, alcohol or intoxicating medication.
8
DO NOT leave the unit in a totally discharged state for an extended period of time as this may result in permanent damage.
8
© Jack Sealey Limited
ROADSTART®, 1200A 12V JUMP STARTER &
TYRE INFLATOR
MODEL NO:
Wear
Keep in dry
protective
area. Protect
gloves
from rain
Original Language Version
RS1200TI
Warning
Electrical
shock
corrosive
hazard
substance
Keep away
Use in well
from sources
ventilated
of ignition
areas
RS1200TI
Issue 2 (3,F)
Warning:
Explosive
material
07/11/23

Advertisement

loading

Summary of Contents for Sealey ROADSTART RS1200TI

  • Page 1 RS1200TI MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2 Connect 5V/2A input port of jump starter to the other end of car adaptor. NOTE: DO NOT charge the jump starter unit immediately after starting engines, but wait at least 30 minutes. RS1200TI Issue 2 (3,F) 07/11/23 Original Language Version © Jack Sealey Limited...
  • Page 3 H--: The motor has reached the maximum single working time of 15 minutes, and the product stops working at this time. It is recommended to cool down for at least 30 minutes before using the secondary air pump function. RS1200TI Issue 2 (3,F) 07/11/23 Original Language Version © Jack Sealey Limited...
  • Page 4 Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk...