Sealey AB3412 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Warning!
Automatic
instructions
start-up
THIS PRODUCT IS NOT SUITABLE FOR PRIMARY HEATING PURPOSES
1. SAFETY
1.1. ELECTRICAL SAFETY
WARNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical
products. You may obtain an RCD by contacting your local Sealey Stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information, it is important that the following information is read and understood.
1.1.1. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3. Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired or is
8
replaced immediately by a qualified electrician.
1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply off and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2. GENERAL SAFETY
▲ DANGER! Risk of carbon monoxide poisoning. Failure to provide proper ventilation could result in serious illness or death.
Check that the heater is in sound condition and good working order. Take immediate action to repair or replace damaged parts.
9
Use recommended parts only. Unapproved parts may be dangerous and will invalidate the warranty.
9
Only use clean kerosene or diesel (NOT BIO-DIESEL) to fuel your heater, in accordance with instructions contained in this manual.
9
WARNING! Only use heater in well ventilated areas. Ensure continuous ventilation from outside of the building is provided to the
‰
heater operating area. Allow at least 3ft² opening/100000Btu/hr output.
Keep the front of the heater a minimum of 2.4 metres and the rear and sides 1.2 metres from any combustible materials (i.e. wooden
9
items, cloth, plastics, paper,tarpaulins or similar enclosure materials).
Only operate on a level and stable surface.
9
WARNING! DO NOT use the heater near flammable material, liquids, solids, gases or compressed gas cylinders.
‰
DO NOT use the heater in closed rooms, living areas, basements or below ground level.
8
DO NOT allow untrained persons to operate the heater and DO NOT operate the heater without the cover.
8
DO NOT move or handle the heater when hot.
8
DO NOT leave the heater unattended when in use. Switch the heater off and unplug from the mains before leaving work area.
8
DO NOT fill the fuel tank whilst the heater is running or still hot.
8
DO NOT overfill the fuel container. Wipe up any spilt fuel immediately.
8
DO NOT obstruct the air inlet (rear) and air outlet (front) of the heater. DO NOT use duct work in front or at the rear of the heater.
8
DO NOT look into the exhaust end of the heater.
8
DO NOT allow children or animals near the heater when in use, or while hot.
8
WARNING! RISK OF ELECTRIC SHOCK. DO NOT expose the heater to water spray, rain, dripping water or wind.
‰
DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT touch the heater outlet or dome when first switched off as these are very hot and will take time to cool.
8
Ensure that the heater is correctly turned off when not in use and store in a safe, dry area, out of reach of children.
9
© Jack Sealey Limited
340,000BTU/HR SPACE WARMER®
KEROSENE/DIESEL HEATER WITH WHEELS
MODEL NO:
Hot surfaces Warning
Original Language Version
AB3412
Do not cover Electrical shock
hazard
Recommended fuse rating
13Amp
AB3412 Issue 2 (3) 03/02/2021