Alarm Operation - Sharp FV-DB1E Operation Manual

Alarm operation

At the set time, the alarm sounds or the radio turns on.
Once set, the alarm performs the operation every day.
Use when...
You want to use the alarm as a wake up call, or listen to the radio at
the same time every day.
Before setting alarm:
1 When setting the alarm, connect the AC adaptor to the unit.
If batteries are the only power source, you cannot set the
alarm (see page 6).
2 If the clock is not set, the alarm setting is not available ("No
time date" appears). Receive a DAB station to set date and
time (see page 8, 9).
1
Press the ON/STAND-BY button to turn the power on.
2
To use "Radio" as an alarm, tune in to a station and adjust
the volume.
To use "Tone" as an alarm, proceed to step 3.
3
Press the CLOCK button repeatedly to
select "Set alarm ok?", then press the
ENTER button.
4
Within 30 seconds, press the TUNING
( or ) button to specify the hour to
start, then press the ENTER button.
5
Within 30 seconds, press the TUNING
( or ) button to specify the minutes
to start, then press the ENTER button.
6
Within 30 seconds, press the TUNING
( or ) button to select the desired
alarm type.
Tone: The alarm sounds at the set time, and stops after 5
minutes. The volume gradually increases from 0 and
reaches 40 after 1 minute.
Radio: The radio turns on at the set time, and turns off after
1 hour. The volume gradually increases from 0 and
reaches the level set in step 2 after 1 minute.
7
Within 30 seconds, press the ENTER
button.
" " will light up.
8
At the set time, the alarm operation will start.
" The current date/time and the remaining time appear alternately.
" The volume decreases 1 minute before the alarm operation
finishes.
04/4/12 FV-DB1E_2.fm
FV-DB1E
5
15
TINSEA025SJZZ